The säge saga

I helped one of my son’s friends build a bookshelf unit over the weekend. At the end, he had a piece of thin plywood for the back, that proved a little tricky to cut on the table saw. No problem, I said, I’ll use the circular saw.

Except it proved to be suddenly dead.

Well, I said, I can cut it with the blade on the angle grinder. But even with a very light load, it bogged, then started smoking. So the hell with tricky. We managed to cut it on the table saw, and finished the project.

Yesterday I dismantled the circular saw and tested the switch, then remembered that when I bought it from a German guy several years ago he had given me something else, replacement brushes for the motor. After a bit of searching, I came up with one, and dismantled the saw further. Voilà! Relatively painless to replace the brush, reassemble the saw, and it’s back in action!

saw1
Walter the German handkreissäge is happy again.

Not so the angle grinder (amoladora). It addition to being more challenging to dismantle, in the end I couldn’t get to the switch, which I suspect partially melted.

saw2
And I thought Hyundai made quality stuff.

It is the only thing I’ve bought here for which I cannot find a receipt, but I’m pretty sure it’s been over a year, if it even had a guarantee that long (the cheap Chinese power tools come with a two-month guarantee: inspires confidence!).

So, this becomes another addition to the next Montevideo trip: find their service center and see if it can be repaired. It may not be worth it, but anything with electronics, a motor, or an engine costs 60-100% more here than up north.

Leave a Reply

Your email address will not be published. Required fields are marked *